Author Topic: HA5-P3  (Read 7001 times)

Rong Wei

  • Sr. Member
  • ****
  • Posts: 43
  • Karma: 0
    • View Profile
HA5-P3
« on: October 17, 2015, 02:55:31 PM »
previous post should be HA5 - P1, sorry about the typo!

Rong Wei

  • Sr. Member
  • ****
  • Posts: 43
  • Karma: 0
    • View Profile
Re: HA5-P3
« Reply #1 on: October 17, 2015, 04:18:42 PM »
and for question b, it should be x - ct instead of x - vt; otherwise, we couldn't have the solution.

Emily Deibert

  • Elder Member
  • *****
  • Posts: 100
  • Karma: 0
    • View Profile
Re: HA5-P3
« Reply #2 on: October 17, 2015, 08:17:51 PM »
I'll add my typed solutions.

(a) The ordinary heat equation is: \begin{equation}
u_t = ku_{xx} \end{equation}

Now consider $U(x,t) = u(x+ct,t)$. The partial derivatives needed for the heat equation are given by: \begin{equation}
\begin{cases}
U_t = cu_x + u_t \\
U_x = u_x \\
U_{xx} = u_{xx} \end{cases} \end{equation}

Now let's plug these into the heat equation: \begin{equation}
U_t = kU_{xx} \longrightarrow (u_t + cu_x) = k(u_{xx}) \longrightarrow u_t + cu_x = ku_{xx} \end{equation}

Therefore the heat equation with a convection term is obtained from the ordinary heat equation with a change of variables.

(b) Now we use the change of variabes $u(x,t) = U(x-ct,t)$ (Note: Thank you Rong Wei for pointing out the fact that this should be c here, as I was unable to solve the problem otherwise!). Now the partial derivatives are given by: \begin{equation} \begin{cases}
u_t = -cU_x + U_t \\
u_x = U_x \\
u_{xx} = U_{xx} \end{cases} \end{equation}

Let's plug this into the heat equation with a convective term: \begin{equation}
u_t + cu_x = ku_{xx} \longrightarrow (-cU_x + U_t) + c(U_x) = k(U_{xx}) \longrightarrow -cU_x + cU_x + U_t = kU_{xx} \longrightarrow U_t = kU_{xx}
\end{equation}
So with this change of variables, the equation reduces to the familiar heat equation.
We can then use the usual formula to arrive at the solution: \begin{equation}
u(x,t) = \int_0^{\infty}G(x-ct,y,t)g(y)dy =  \frac{1}{2\sqrt{\pi{}kt}}\int_0^{\infty}e^{-(x-ct-y)^2/(4kt)}g(y)dy \end{equation}

(c) I don't think we can use the method of continuation directly to solve IVBP with Dirichlet or Neumann boundary conditions as $x>0$ for the heat equation with a convection term on ${x>0, t>0}$. This is because we used a change of variables to define the problem.

(d)We have \begin{equation}
u(x,t) = v(x,t)e^{\alpha{}x + \beta{}t} \end{equation}

The partial derivatives are given by: \begin{equation} \begin{cases}
u_t = v_te^{\alpha{}x + \beta{}t} + \beta{}ve^{\alpha{}x + \beta{}t} \\
u_x = v_xe^{\alpha{}x + \beta{}t} + \alpha{}ve^{\alpha{}x + \beta{}t} \\
u_{xx} = v_{xx}e^{\alpha{}x + \beta{}t} + 2\alpha{}v_xe^{\alpha{}x + \beta{}t} + \alpha{}^2ve^{\alpha{}x + \beta{}t} \end{cases} \end{equation}

Let's plug them in to the heat equation with a convection term. \begin{equation}
v_te^{\alpha{}x + \beta{}t} + \beta{}ve^{\alpha{}x + \beta{}t} + cv_xe^{\alpha{}x + \beta{}t} + c\alpha{}ve^{\alpha{}x + \beta{}t} = ke^{\alpha{}x + \beta{}t}(v_{xx} + 2\alpha{}v_x + \alpha{}^2v) \end{equation}

Gathering like terms, we arrive at: \begin{equation}
v_t + v(\beta{} + c\alpha{} - k\alpha{}^2) + v_x(c-2k\alpha{}) = kv_{xx} \end{equation}

For this to reduce to the heat equation, we want the coefficients in front of $v$ and $v_x$ to be zero. So: \begin{equation} \begin{cases}
\beta{} + c\alpha{} - k\alpha{}^2 \\
c-2k\alpha{} \end{cases} \end{equation}

Solving first for $\alpha{}$, we get that $\alpha{} = \frac{c}{2k}$. We can then plug this into the equation for $\beta{}$ and solve to get that $\beta{} = \frac{-c^2}{4k}$.

(e) I will work on this part in a little while. So far I think I have gotten all of the same solutions as Rong Wei. Added my solution below.
For the case of the half-line and Dirichlet boundary condition, we will have the solution: \begin{equation}
u(x,t) = \frac{e^{\alpha{}x + \beta{}t}}{2\sqrt{\pi{}kt}}\int_0^{\infty}[e^{-(x-y)^2/4kt} - e^{-(x+y)^2/4kt}]g(y)dy  \end{equation}
In the case of Neumann boundary conditions, we cannot use a similar method.
« Last Edit: October 17, 2015, 09:02:49 PM by Emily Deibert »

Rong Wei

  • Sr. Member
  • ****
  • Posts: 43
  • Karma: 0
    • View Profile
Re: HA5-P3
« Reply #3 on: October 17, 2015, 09:25:59 PM »
I think the e) solution posted by Emily is right! thank you

Zaihao Zhou

  • Full Member
  • ***
  • Posts: 29
  • Karma: 0
    • View Profile
Re: HA5-P3
« Reply #4 on: October 18, 2015, 03:10:07 PM »
(e) I will work on this part in a little while. So far I think I have gotten all of the same solutions as Rong Wei. Added my solution below.
For the case of the half-line and Dirichlet boundary condition, we will have the solution: \begin{equation}
u(x,t) = \frac{e^{\alpha{}x + \beta{}t}}{2\sqrt{\pi{}kt}}\int_0^{\infty}[e^{-(x-y)^2/4kt} - e^{-(x+y)^2/4kt}]g(y)dy  \end{equation}
In the case of Neumann boundary conditions, we cannot use a similar method.

I don't think the solution is right here, unless we assume $v(x,0) = g(x)$. But usually we use $u(x,0) = g(x)$, then in this case \begin{equation}u(x,0) = v(x,0)e^{\alpha x} = g(x) \rightarrow v(x,0) = g(x)e^{-\alpha x} \end{equation}
Dirichlet condition transforms to:
\begin{equation} u(0,t) = v(0,t)e^{\beta t} = 0 \rightarrow v(0,t) = 0  \end{equation}
Thus we need to solve \begin{equation}v_t = kv_{xx} \end{equation}
\begin{equation} v(x,0) = g(x)e^{-\alpha x} \end{equation}
\begin{equation} v(0,t) = 0 \end{equation}
The answer is then the general result:
\begin{equation}
v(x,t) = \frac{1}{2\sqrt{\pi{}kt}}\int_0^{\infty}[e^{-(x-y)^2/4kt} - e^{-(x+y)^2/4kt}]g(y)e^{-\alpha y}dy  \end{equation}
Then
\begin{equation}
u(x,t) = \frac{e^{\frac{c}{2k}x -\frac{c^2}{4k}t}}{2\sqrt{\pi{}kt}}\int_0^{\infty}[e^{-(x-y)^2/4kt} - e^{-(x+y)^2/4kt}]g(y)e^{-\frac{c}{2k} y}dy  \end{equation}
« Last Edit: October 18, 2015, 03:26:41 PM by Zaihao Zhou »

Emily Deibert

  • Elder Member
  • *****
  • Posts: 100
  • Karma: 0
    • View Profile
Re: HA5-P3
« Reply #5 on: October 18, 2015, 04:46:19 PM »
Oh I see, this makes sense. I think I misunderstood what the question was asking.

Bruce Wu

  • Sr. Member
  • ****
  • Posts: 57
  • Karma: 0
    • View Profile
Re: HA5-P3
« Reply #6 on: October 20, 2015, 01:09:01 AM »
Shouldn't the integral bounds in equation (6) be from $-\infty$ to $\infty$ instead of $0$ to $\infty$? Here the domain is not restricted yet. This is what is in Rong Wei's written solution also.

Victor Ivrii

  • Administrator
  • Elder Member
  • *****
  • Posts: 2607
  • Karma: 0
    • View Profile
    • Personal website of Victor Ivrii
Re: HA5-P3
« Reply #7 on: October 20, 2015, 02:30:30 AM »
In the original problem on the line indeed integral is from $-\infty$ to $+\infty$.

We cannot apply method of continuation directly to IBVP equation with the convective term because equation contains $\partial_x$ in the odd degree and replacing $x\mapsto -x$ we change the equation. We cannot apply this method after change of $x-ct= x_{\mathsf{new}}$ because domain now is not $\{x>0\}$ but $\{x+ct>0\}$.

However as we plug $u=e^{\alpha x+\beta t}$ we get the normal heat equation and the domain $\{x>0\}$ and the boundary condition
$u|_{x=0}=0\implies v|_{x=0}=0$ and we can use method of continuation
$u_x|_{x=0}=0\implies (v_x+\alpha v)|_{x=0}=0$ and we cannot use method of continuation (unless $\alpha=0\iff c=0$).