Author Topic: Q3 TUT 5101  (Read 605 times)

Victor Ivrii

• Elder Member
• Posts: 2439
• Karma: 0
Q3 TUT 5101
« on: October 12, 2018, 06:19:19 PM »
Let $D$ be the domain obtained by deleting the ray $\{x\colon x \le 0\}$ from the plane, and let $G(z)$ be a branch of $\log z$ on $D$. Show that $G$ maps $D$ onto a horizontal strip of width of $\pi$,
$$\{x + iy\colon - \infty < x < \infty,\ c_0 < y < c_0 + 2\pi\},$$
and that the mapping is one-to-one on $D$.

Draw both domains.$\newcommand{\Arg}{\operatorname{Arg}}$
« Last Edit: October 14, 2018, 07:17:42 AM by Victor Ivrii »

Kathy Ngo

• Jr. Member
• Posts: 5
• Karma: 3
Re: Q3 TUT 5101
« Reply #1 on: October 14, 2018, 12:20:54 AM »
Fix $G(z)$ such that $G(z)=\ln|z|+i(Arg(z) + c_{0} +\pi)$ where $c_{0} \in \mathbb{R}$
let $x=\ln|z|$ and $y=(Arg(z) + c_{0} +\pi)$

Note that
$\forall z\in D, |z|\geq 0 \Rightarrow x=\ln|z|\in(-\infty, \infty)$
and
$\forall z\in D, Arg(z) \in (-\pi, \pi) \Rightarrow y=Arg(z) + c_{0} +\pi \in (c_{0} , c_{0}+2\pi)$
Therefore $G$ maps $D$ onto $\{x+iy: -\infty < x< \infty, c_{0} <y<c_{0}+2\pi\}$.

Suppose $G(z_{1}) = G(z_{2})$ then
$\ln|z_{1}|+i(Arg(z_{1}) + c_{0} +\pi)=\ln|z_{2}|+i(Arg(z_{2}) + c_{0} +\pi)$
therefore, we have
$\ln|z_{1}| = \ln|z_{2}|$
$Arg(z_{1}) + c_{0} +\pi = Arg(z_{2}) + c_{0} +\pi \Rightarrow Arg(z_{1})=Arg(z_{2})$
these two equations imply $z_{1} = z_{2}$, hence the mapping is one-to-one on $D$.
« Last Edit: October 14, 2018, 12:24:00 AM by Kathy Ngo »

Victor Ivrii

• Elder Member
• Posts: 2439
• Karma: 0
Re: Q3 TUT 5101
« Reply #2 on: October 14, 2018, 07:23:46 AM »
Arguably you need to type Arg upright and provide a proper spacing after it. The trouble is that LaTeX (and Mathjax) would not recognize \Arg since it was not defined. But one can use \operatorname{Arg} ; however one could do better then this defining (only once!) \Arg
Code: [Select]
\newcommand{\Arg}{\operatorname{Arg}}(I did it).

Similarly, one can change existing definition
Code: [Select]
\renewcommand{\Re}{\operatorname{Re}}

On the pictures do not use  xxxxxx for "cuts". Just straight line